"Porto Spans"

Hello folks,
I've had several requests to do a run of my Porto Spans, so here they are.
The Porto Span is a tool for adjusting the pivot tension on a Strider knife. It is made from 316 series Stainless Steel and features both the spanner for the large Strider knives (NOT FOR THE PT MODEL) as well as an 1/8 hex wrench. The two halves screw together using a 1/4-28 thread with an "O" ring at the bottom of the thread to keep debris out. Dimensions are 3/8 thick x 5/8 wide x 1 & 3/8 long.

 ATTENTION PLEASE:

If  you have not adjusted the pivot on your Strider knife before, I suggest that you hold the end of the knife with the pivot pin in very hot if not boiling water for a minute to loosen any thread lock (Loctite) that the good folks at Strider may have applied.

USA price is $60.00.

Other worldly destinations, your price is $80.00.

A USPS Money Order is acceptable as well.

Please send an Email to jordanmetalart@gmail.com if you'd care to make a purchase.

Thanks for dropping by,

Kenn