Bronze Micro Bit Twist SUS

Hi folks,
If you've been keeping tabs on the JMA Facebook page, you know I'm making good progress on the latest Nebuli knife run.
While I was running the blade "grind" operation this past weekend, I had ample cycle time to produce some  "Bronze Micro Bit Twists".
I have 14 tools available for a sign up sale.
This tool is .375 thick x .625 wide over the .312 radii x .625 high not including the bit.
The bit holder is a 1/4 hex machined .400 deep. In one side is a  #8-32 socket set screw to hold the bit in place
To top it off, there is a small split ring attached, so you can put this on your key chain.
While the tool comes with a #2 Phillips bit you can replace it with any 1/4 hex bit that is to your liking. A 5/64 short arm Allen wrench is included.
USA = $45.00
OCONUS = $64.00
Sign is Closed.
Here are the winners:

1	Andrew W
39	Frederico F
28	Jeff P
2	Gary g
18	Outils
37	Slappybonehead
35	Nick F.
14	TCBOR
12	Otis M
36	Kendall
11	Dave Au
21	tim f
40	Kim S
8	fishfinder go

 Winning Email notifications are sent from SignUpSale.com , so be sure to check your spam folder.
Thank you for dropping by,
Kenn